This M10 in .45ACP was manufactured by MAC in Powder Springs and is a pre-1986 transferable machine gun. It is one of the most affordable, entry level, machine guns on the market. Aftermarket and replacement parts for the M-10 are easily available, as are complete replacement uppers to slow the rate of fire and bring the M10 up to date with modern firearms.
The pictured M-10 is in good condition and is a shooter. Wear is as expected with the age of the firearm, and while there is some finish wear as expected on an M10, there is no damage to the welds, holes, fire controls, or other important components. The wear is most apparent on the grip of the M10. It has no signs of abuse or neglect, and appears to have been stored well over the past few decades. The internal components are in good and functioning order with no signs of any repairs being needed. One of the holes on the rear plate below the sight aperture appears to have slight damage, as though it was used for a sling mount. This does not affect the structural integrity of the firearm.
It is currently in factory configuration with the top-folding wire stock and factory upper.
Additionally, it includes a Bowers VERS 45 suppressor as well as a full 9mm conversion kit.
Included Accessories and Parts
- Additional vertical foregrip
- Barrel shroud (x3)
- Bowers VERS 45 suppressor
- 2 magazines
- Side-charging 45 ACP upper receiver
- Side-charging 9mm upper receiver
- 9mm mag-well conversion
- 2 9mm magazines